Datum target
The target point will be displayed at the start point you indicate. X Point - When checked, a target point will be displayed as an x (x) point. As a condition in manufacturing and inspection equipment, the datum has to give. When checked, no target point will be displayed.Ĭross Point - When checked, a target point will be displayed as a cross (+) point. An onlay target is a place with points and lines that are on the workpiece. None - A target point is comprised of a leader/point marker that connects the actual the target symbol to its start point. The following options are available from the Point Type drop-down menu: Select 3 positions for datum targets on the largest surface of the part, positioning them as far apart as. Solid – When checked, a solid leader line will be displayed.ĭashed – When checked, a dashed leader line will be displayed. 3 Datum Target Areas on the Primary Datum Plane. Unfilled – When selected, an unfilled leader type is used No leader type is used.įilled – When selected, a filled leader type is used.
The following setup options are available under Leader Type in the dialog: Point Type – Select a point type from the drop-down menu. Leader Type – Select a leader type from the drop-down menu. 3 Edit sketch, select all, convert lines to sketch only. 2 Place datum target and dimension as required. This ID will be displayed within the symbol. I adopted a similar work flow to mcgyvr but I do mine within the drawing environment 1 Start sketch on the required face, draw the datum target with cross hairs to snap to. Movable datum targets may be used in conjunction with targets that are fixed.Īrea Size – Allows you to set an area size to be displayed with the symbol.ĭatum ID – Allows you to "name," or give the datum target symbol a specific ID. Typically, such planes are generated in pairs. Movable Datum Target – When selected (checked), the targets being created will be moveable, which will allow them to be used in generating equalized center planes. When unchecked, the size is based within the symbol. Size Outside - This is a toggle setting that, when checked, will cause the size value to be placed outside of the symbol. The following setup options are available in the Datum Target dialog box: The following Datum Target dialog is displayed when Datum Target Symbol is selected from the Detail Menu:
Top Hole and Bottom Hole Centers were established from the Unrelated Actual Material Envelope, Rather than the Related Maximum Material Boundary (ASME Y14.5-2009, Fig. Datum Target Dialog Options Ke圜reator / Detail / Symbol / Datum Target / Datum Target Dialog Options The simulated Datum Frame (Plane Orients, Top Hole Locates, Bottom Hole Orients) implies the Top Hole has priority over the bottom Hole.